In the extruded profiles made from aluminum profiles cooling, transport, stretching, verification, measuring and cutting takes place at this table. In this table, starting with high heat resistant roll belt pads and rolls according to the appropriate temperature profiles moved from the stretching process is carried out and the profile height measurement, and finally subjected to cutting process.

After molding, extruded profiles, though due to the high temperature will be bent by bending. Thus profile, even after cooled at cooling table conveyor will be taken up by the tensioning machine. The function of the stretching machine, stretching to flatten profile. Stretching machine normally pack header, tail, and will consist of machine base.

Profile, thermal oven should be shortened before entering short. Finishing saw; the function of the profile is cut according to customer's request (Minimum: 1.5 meters, maximum: 7 meters) . Oil sprayed during the process and cutting burrs and chips are collected by vacuum suction system. Oil quantity and timing can be programmed. After cutting down the knife and come back to its original position.

Using DC drives with DC motors with gear chain catches in coordination of aluminum. According to the extrusion speed and the pressure jaw twisting power and shutter speed can be adjusted so that the profiles are provided accurate and precise withdrawal.

Furnace; single-billet heater consists of hot shear and loading rack. Billet will heat up with direct fire from the furnace. Heating is very fast and takes less than 30 minutes, and immediately after the initial manufacturing can begin. Complete the process, every 12 seconds is automatically controlled by a PLC, and is used to match the desired range of temperature. Furnace and real-time data about billet is available to see on 10.4-inch LCD screen. Cut length, billet temperature and the like. The data display can be adjusted by the customer. Cut length, is controlled by the encoder.

Temperature control is fully automatic. Fans for circulating hot air is used. Include stainless steel basket to hold the die. When the mold temperature reaches the desired pattern using the lever, can be pressed.

In Aluminum Extrusion press handling tables is used the high heat resistance heat resistance up to less than the desired size, thickness, rolls, belts and pads are endless.

After the profile production, the profiles will go to Aging Furnace. In the furnace Kimsan Thermal Spacer Sleeves are used in between profiles to protect them not to get damaged.

The surfaces of the profiles are protected against scratches by placing this product between each layer of profile.

It is available in any size required.